Enabling Devices 1521 Uživatelský manuál stáhnout pdf (Strana 20)

RPM1521

3-3-4 SNMP/SysLog

This menu allows the administrator to configure the RPM1521 to send SNMP Traps and

System Logs to different Network Management Stations (NMS).

System Name: Enter the name of the SNMP device.

System Contact: Enter the name of the System Administrator.

System Location: Enter the location of the SNMP device.

Receiver IP Address: The IP Address of the NMS of where the Traps should be sent.

Receiver Port: The port that will be used to receive the Traps. The default value is 162.

Community: Low-level password of the associated IP address with the access type set by

the administrator.

Enabled: Enables the SNMP Traps to be sent.

SNMP Test: This is used to verify that the Trap notification works properly.

Syslog Server Address: The IP Address of the Server to which the System Logs should be

sent.

Syslog Server Port: The port that will be used to receive the System Logs.

Enabled: Enables the System Logs to be sent.

SYSLOG Test: This is used to verify that the SYSLOG works properly.

Save: Once the setup is complete click the Save button to save all of the changes.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Žádné komentáře

Enabling Devices 1521 Uživatelský manuál Strana 20